I am having problems with Knowbrainer recognizing a command.  I totaled the command major problem <1to25>.  When I dictate major problem 7, it does not go to the command but types major problem 7.  I must be doing something wrong that is simple to fix, but I cannot figure it out.  I appreciate any help.  The command is a loop command, and when I refresh Knowbrainer there were no problems with the command in terms of scripting.

Please copy the code from your Dragon Medical or KnowBrainer command into a post so that we can review it. That's the only way we're going to be able to answer this question.

-------------------------

Click KB 2012 REV D to Download a 30 Day Evaluation of KnowBrainer 2012 

 

 

 

 Command name:  major problem<1To25>

I=Val(_arg1)
Do until I=0

HeardWord "dot"," major"," problem"
wait 500
HeardWord "beginning","of","line"

Wait 500

SendKeys "{Down}"

Wait 500
I = I-1
Loop

This is programmed in KB.  Dot Major Problem is a commad that types ".MP:" for my EMR.  Basically I end up with a list of surgeries and hospitalizations and I want this command to type .MP: in front of all of them.  Right now I use the mouse to click back.  Saying the commands as I programmed them works fine.  I just want to say one command an have them all done. 

Thanks,

Dan